This
is a steel templates for doing the UCA drop on 1967 through 1970
Mustangs. This template is made of 1/16" plate steel and is CNC cut for
accuracy. It bolts into the
shock tower in the stock A-arm location and allows you to drill
two pilot holes in the improved suspension location. The template
is then removed and the pilot holes can then be enlarged to accept the
UCA bolts.
If you are ordering this template for a car other than a Mustang,
before ordering please measure the distance
between the UCA studs on your car. A 3.75" measurement requires
the 64-66
template and a 4.75" measurement requires the 67-70
template.
In
order to properly perform the UCA drop a 17/32" drill bit is
required to correctly size the new holes. This bits can be hard
to find locally and often times they are expensive. If you need a
bit I sell them individually or they can be purchased with a template
as a "kit". Please see "suggested parts" below if you ate needing
a 17/32" drill bit
Only one template is needed as you use the same template to drill the
pilot holes on both sides.
|
|